series resistor

英 [ˈsɪəriːz rɪˈzɪstə(r)] 美 [ˈsɪriːz rɪˈzɪstər]

网络  串联电阻; 串联电阻器

计算机



双语例句

  1. A resistor at high frequency acts like a series combination of inductance with the resistor in parallel with a capacitor.
    工作在高频的电阻表示为电感跟并联的电阻、电容之间的级联。
  2. In this paper, math model is studied based on physics theory of PV cell, and the influence of series resistor Rs and parallel resistor Rsh on PV cell characteristic is analyzed.
    针对光伏电池研究了基于物理机制的数学模型,分析了串联电阻和并联电阻对光伏电池特性的影响。
  3. In this case, the series resistor should be placed as close to the relay as possible to limit the current when charging the cable capacitance.
    在这种情况下,串联电阻就应该尽量靠近继电器,以限制电缆电容充电时的电流。
  4. Product introduction: RX21 series resistor is lacquered wire wound resistor.
    产品介绍:RX21型电阻器为被漆型绕线电阻器。
  5. The diode and resistor R1, in series with the picoammeter input, serve two functions. First, the resistor will limit the current in case a capacitor becomes shorted.
    二极管和电阻器R1与皮安计的输入串联,其有两个功能:第一,电阻在电容发生短路时起到限流的作用;
  6. The range of a voltmeter may be extended by means of a series resistor called a multiplier as shown in Fig.2.
    如图2所示,采用一种称为倍增电阻的串联电阻器即可扩大伏特表的量程。
  7. The utility model is characterized in that after connected in series, a resistor and a capacitor are connected with a fuse in parallel.
    一电阻和一电容串联后再与熔断器并联。
  8. Another type of termination, AC coupled termination, adds a small capacitor in series with the termination resistor to eliminate the DC loading effect.
    另一种类型终端电阻&AC耦合的终端电阻,增加一只小电容器串联在终端电阻上就消除了它的DC负载效应。
  9. Squirrel cage induction motor with two stators has the advantages of high starting torque and low starting current of the wound-rotor machine with series rotor resistor, as well as the superiority of Squirrel cage rotor.
    双定子笼型感应电动机具有笼型电动机结构特点和绕线转子电动机串电阻起动的优点,堵转转矩大,堵转电流小。
  10. The one is that the measured hysteresis ( Q~ V curve) of ferroelectric capacitor has a error, and the other is that this hysteresis has a gap if the measured circuit is the ferroelectric capacitor in series with a linear resistor.
    用铁电电容和线性电阻串联电路测试的铁电电容电滞回线有一个开口。
  11. Also the status of RYC Series gaps parallel resistor in application of MOA is described.
    给出了RYC型串联间隙并联电阻器在金属氧化物避雷器中的应用情况。
  12. Analysis of the mechanical property of the wound rotor asynchronous motor in series with the frequency variable resistor
    绕线式异步机串频敏变阻器的机械特性分析
  13. Arc Suppression Circuit Connected in Series with Non-linear Damping Resistors& Type DFD Large Capacity Non-linear Resistor
    串联在消弧线圈接地回路中的非线性阻尼电阻&DFD型大功率非线性电阻器
  14. Computer analysis shows that probably the best way of reducing the effect of AM-PM conversion ( i. c. reducing phase noise) is emitter degeneration feedback, a series resistor between the collector and the tuned circuit as well as operating the devices at large emitter current.
    计算机分析表明:串接适当的发射极反馈电阻、集电极防振电阻以及工作在大的发射极电流是降低AM-PM变换的好方法。
  15. The former is composed by parallel diode, series limiting resistor and protection fuses, which can transfer overload pressure, the surge current and overload current to the system "GND" before fire the dangerous environment.
    前者由并联齐纳二极管、串联限流电阻和保护熔断器构成的网络组成,具有在点燃危险环境前把过压、浪涌电流和过载电流安全转移到系统地。
  16. Applying Series Resistor to Restrain Power Transformer DC Biasing
    抑制变压器直流偏磁的串接电阻措施
  17. Several structures to improve the reliability and uniformity of FEA are presented. Then it was suggested that Si FEA with a series resistor feedback be fabricated on the P type substrate of common resistivity by the N ion implantation and dry etching.
    首先介绍了稳定FEA电子发射均匀性和可靠性的几种结构,然后提出了以离子注入和干法刻蚀技术,在常规电阻率P型衬底上制成具有串联电阻负反馈特性的单片硅FEA。
  18. Three voltage compensations and two drop compensations were also designed for the bias voltage and the series resistor respectively. The low-pass filter was designed for the signal processing after the preamplifier.
    同时也为偏置电压设计了三种电压补偿、为串联电阻设计了两种压降补偿、为前置放大器的信号处理设计了低通滤波器。
  19. A new structure of base stability resistor is used, which each HBT is in series with a base stability resistor. The resistors have appropriate resistance that reducing the influence of the process error. 2.
    本文功率放大器设计的创新点在于:1.基极稳定电阻采用每一只HBT与一个电阻串联的结构,电阻值大小适宜,减小了工艺误差对功率放大器性能的影响。